Introduction to Electro Galvanizing

Aug 31, 2022 Leave a message

Electrogalvanizing (also called cold galvanizing) is the most commonly used coating for commercial fasteners, and it is also commonly used in bracket products. In general, the electro-galvanizing process is relatively cheap and has a good appearance, but its disadvantages are also obvious.

1 Principle of electro-galvanizing

Because zinc is not easy to change in dry air, and in humid air, a very dense zinc carbonate film can be formed on the surface, which can effectively protect the interior from corrosion. And when the coating is damaged for some reason and the matrix that is not too large is exposed, the zinc and the steel matrix form a micro-battery, so that the fastener matrix becomes a cathode and is protected.

2Electro-galvanized performance characteristics

1) The zinc coating is thick, the crystals are fine, uniform and free of pores, and the corrosion resistance is good;

2) The zinc layer obtained by electroplating is relatively pure, and corrodes slowly in the mist such as acid and alkali, which can effectively protect the steel substrate;

3) The zinc coating is passivated by chromic acid to form white, colored, military green, etc., which is beautiful and has certain decorative properties;

4) Due to the good ductility of the zinc coating, various forming such as cold punching, rolling and bending can be carried out without damaging the coating.

3.Electro-galvanized classification

According to the classification of electroplating solutions in China, it can be divided into four categories:

Cyanide Zinc

Because (CN) is highly toxic, environmental protection has put forward strict restrictions on the use of cyanide in electro-galvanizing, and constantly promotes the development of cyanide-reducing and replacing cyanide electro-galvanizing bath systems, requiring the use of low-cyanide (micro-cyanide) electroplating baths .

After electroplating by this process, the product quality is good, especially the color plating, and the color remains well after passivation.

Zinc galvanized

This process is evolved from cyanide zinc plating. There are two major factions in China, namely: a) "DPE" series of Wuhan Material Insurance Institute; b) "DE" series of Radio and Television Institute. Both belong to zincate zinc plating with alkaline additives, and the pH value is 12.5~13.

Using this process, the lattice structure of the coating is columnar, and the corrosion resistance is good, which is suitable for color galvanizing.

Note: After the product is out of the tank—>; water washing—>; light output (nitric acid + hydrochloric acid)—>; water washing—>; passivation—>; water washing—>; water washing—>; blanching—>; drying—>; aging Treatment (80~90℃ in the oven.

Chloride Zinc

This process is widely used in the electroplating industry, accounting for up to 40%.

After passivation (blue white), chrome can be replaced by zinc (comparable to chrome plating), especially after adding water-soluble varnish, it is difficult for a layman to distinguish whether it is galvanized or chrome plated.

This process is suitable for white passivation (blue white, silver white).

Sulfate Zinc

This process is suitable for continuous plating (wires, strips, simple, thick and large parts and components), and the cost is low.

H7ef6505676464550b468165ba91556b0W.jpg_960x960

www.jstisco.com




Send Inquiry

whatsapp

Phone

E-mail

Inquiry